Sterling Springdale Concrete and MasonrySterling Springdale Concrete and Masonry

Brick pointing in Springdale AR - joints that hold and mortar that suits your brick

Mortar crumbling or sitting back from your brick? We clear out the worn joints and refill them with mortar matched to your brick.

Close view of a light stone retaining wall beside a mulched garden bed with grasses and purple flowers.
  • Fully licensed and insured.
  • Free in-person estimates.
  • Replies within 1 business day.

Does your brick need pointing, and what goes into it?

The short answer: Brick pointing means cutting the worn, cracked mortar out from between your bricks and packing in fresh mortar, so the wall sheds water again and the bricks stay tight. At Sterling Springdale Concrete and Masonry, we do brick pointing in Springdale, AR and the cities around it, from one tired wall to a whole house.

Most people call after they notice sandy mortar along the foundation or joints that look sunk in, and the first thing I want to know is why they wore out, whether it's plain age, a gutter spilling over or a wall that's moved. The price mostly turns on how much wall needs work, how high it goes and how gently the brick has to be handled, and the schedule mostly turns on the weather, because mortar needs mild days to cure. A few worn joints on a wall that stays dry can usually wait a season, and when I come out I'll tell you if yours can and walk you through what yours will take.

How can you tell your brick needs pointing?

  • Mortar sitting back from the brick

    If the mortar line sits recessed behind the brick face, years of rain have worn the joints away. Left alone, water collects on that little ledge, soaks into the wall and chips at the brick edges every time it freezes, so the job keeps getting bigger.

  • Mortar that crumbles like sand

    When you can scratch a joint out with a key, the mortar has lost its strength and isn't holding much anymore. Bricks held by soft mortar can work loose, and resetting loose brick is a bigger job than pointing around it.

  • Cracks along the brick edges

    A thin crack where the brick meets the mortar lets water in behind the face of the wall. If the cracks climb across the wall in a stair-step line, the wall may be moving, and I'd want to know why before anyone points it.

  • Holes and gaps in the joints

    Gaps where mortar has dropped out, often near the ground or under a gutter that runs over, let water and insects into the wall. These spots tend to spread to the joints next to them, so they're cheaper to deal with early.

How we do brick pointing on your house

I start by looking at how old your house is and what the brick is like, because that decides the mortar, and I'm glad to tell you how the mix we pick compares with your brick. Our crew cuts the worn mortar out until they reach sound material, clears the dust so the new mortar can grip, and dampens the joints so dry brick doesn't pull the water out of the mix too fast. We pack the new mortar in layers, tool each joint to the same shape as the old ones and keep the work damp while it cures so it doesn't dry weak. Then we clean the smears off the brick, and we work to match the color and texture so the new joints look like they belong on your house.

Pointing fixes the joints, but it won't fix whatever cracked them. If the cracks step across the wall or a corner has dropped, the house may be settling, and that calls for foundation repair so the new mortar doesn't split the same way. Chimneys take more weather than any wall on the house, so when we find loose brick, a cracked crown or a lean up there, we take it on as chimney repair.

  • Spot pointing worn sections

    This suits a house where most of the mortar is sound and one area took the beating, like the wall under a leaky gutter or the bottom rows beside a flower bed. We sort out what caused the wear too, or the new joints go the same way.

  • Repointing a whole wall or house

    When the joints are tired everywhere, doing the full wall at once gives you one mortar and an even color instead of a patchwork. It costs more up front than spot work, but once more than a few patches are failing it's the better choice.

  • A gentler approach for older brick

    Soft, older brick needs extra care when the old mortar comes out. Preservation guidance for historic buildings favors hand chisels and mash hammers, which take more labor but in most cases risk the least damage, and it warns that power saws and grinders in unskilled hands can ruin soft brick.

What happens after you call about brick pointing in Springdale?

Here's how a pointing job goes with us, from the first call to the walk-through at the end. I handle the visit and the estimate myself, and our crew does the work.

  1. Step 01

    Call or send the form

    Call (479) 231-3391 or send the form, and tell us what you're seeing on your brick. We'll set a time for me to come out.

  2. Step 02

    I look it over in person

    I check the joints, the brick and the age of the house, and I look for what's behind the wear, like a gutter dumping water or a wall that's shifted. Then I walk you through the estimate, so you know what's causing the trouble, which walls need work, what mortar we'd use and what it will cost before you decide anything.

  3. Step 03

    We point the joints

    Before we start, we check with the city or county office for your address and apply for a permit if one's needed. Pointing is slow, careful and noisy work, and scaffolding may stand against part of the house for a while, so we'll tell you ahead of time which doors and windows it affects.

  4. Step 04

    Walk the finished job

    Once the joints are done and the brick is cleaned, we go over the walls with you. If anything doesn't look right to you, that's the time to say so.

Brick pointing in Springdale through the cold months

The weather sets the calendar for pointing here more than anything else. Across northern and western Arkansas, freezes typically show up by the last week of October and usually hang on into April, sometimes into early May up north, based on long-term averages. Fresh mortar needs warmth to cure, and one federal guide for historic buildings calls for heated mixing water when the air is below 40 degrees F and keeps the mortar above 40 degrees F for at least 48 hours after the work. So a late fall or early spring job takes extra steps or a wait for a warmer stretch, and we'll talk through which makes more sense for your walls.

We're based in Springdale and work across the cities around it in northwest Arkansas, from older brick homes with soft brick to newer houses with harder brick and modern mortar. We meet the same range of houses and weathered joints on jobs in Fayetteville and Rogers, and we choose the mortar the same careful way there.

Get a brick pointing estimate for your house

We reply within one business day to set up a visit. I come out, look over your brick, figure out what's behind the trouble and walk you through a free estimate with no obligation.

(479) 231-3391

Why Springdale homeowners call Sterling Springdale Concrete and Masonry

  • I come out and see it myself

    I'm the one who looks at your brick and gives the estimate, and I'm on site most of the time while our crew does the work. You deal with the same person from the first look to the walk-through, so nothing gets lost between the estimate and the job.

  • Finding the cause since 2013

    I came to masonry after years working on machinery, learned the trade alongside an experienced mason and started this business in 2013, so that's 13 years of working out why walls fail. A patch over the real problem just comes back, so I'd rather find the leaky gutter or the settling first.

  • Fully licensed and insured

    Arkansas lists masonry on its home improvement license application, and a Limited license covers only residential projects under $50,000, labor and material included, while an Unlimited one covers any size. We're fully licensed and insured, and you should ask the same of any mason you're considering.

The mortar is the part of this job you can't easily undo, so it pays to get it right the first time. Call or send us a note and I'll come take a look.

Brick pointing questions from Springdale homeowners

Are tuckpointing and repointing the same thing?

Yes, tuckpointing and repointing are the same job under two names, and brick pointing means the same thing too. All of them mean removing defective mortar from the joints between bricks and replacing it with new mortar.

How do I know if my brick needs repointing?

Your brick needs repointing when the mortar has worn back more than 1/4 inch from the face, crumbles, has holes, or shows hairline cracks, especially where the brick meets the mortar. You can walk around the house and check for these before you call, and photos of the worst spots help me see what you're seeing.

How long does mortar last on a brick house?

Mortar lasts roughly 25 to 50 years, while the brick itself lasts approximately 100 years or more. That's why an older brick home in Springdale can need repointing while its bricks are still sound, and why new mortar, not new brick, is usually the fix.

Why does an older home need a weaker mortar?

New mortar needs to be weaker than the brick, because mortar that's stronger than the brick can make the brick faces spall, or flake off. Homes from the early 1900s or older call for even more care in choosing and mixing it, since their original mortar was sand and lime with no portland cement and is far weaker than modern mortar.

How much does brick pointing cost in Springdale?

There's no set price, because the cost depends on how much wall needs work, how deep the joints are worn, how high we have to reach and whether soft brick calls for slower hand work. A few patches cost far less than a whole house, and a two-story wall or a chimney adds scaffolding. I'll give you your own figure when I come out for the estimate.

How do I choose a mason for brick repointing?

Ask to see repointing jobs they've done, not just brick they've laid, because brick industry guidance notes that an excellent bricklayer may not be skilled at repointing. The same guidance suggests asking for prior repointing projects or having a candidate work on a section of wall that's out of sight first. It's also fair to ask which mortar they plan to use and how it compares with your brick.

  • Foundation repair

    Stair-step cracks running through your mortar often mean the house has shifted, and fixing that movement first keeps fresh joints from splitting open again.

  • Chimney repair

    A chimney with loose brick, a cracked crown or a lean usually needs more than new mortar, and catching it early keeps water out of your attic.

Send photos of your worn mortar joints

Call (479) 231-3391 or send the form with a few photos of the cracked or crumbling joints and your home's rough age, so I come out already knowing what to look for.

(479) 231-3391Request an estimate